Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 1624

Parameters Defaults Command Modes Command History Usage Information ip-address1 ... ip-address12 Not configured. VRRP Version 8.3.11.1 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 Version 7.4.1.0 pre-Version 6.2.1.1 Enter an IP address of the virtual router in dotted decimal format. The IP address must be on the same subnet as the interface's primary IP address. (OPTIONAL) Enter up to 11 additional IP addresses of virtual routers in dotted decimal format. Separate the IP addresses with a space. The IP addresses must be on the same subnet as the interface's primary IP address. Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced support for telnetting to the VRRP group IP address assigned using this command. Introduced on the E-Series. The VRRP group only becomes active and sends VRRP packets when a virtual IP address is configured. When you delete the virtual address, the VRRP group stops sending VRRP packets. A system message appears after you enter or delete the virtual-address command. To guarantee that a VRRP group becomes MASTER, configure the VRRP group's virtual address with the same IP address as the interface's primary IP address and change the priority of the VRRP group to 255. You can ping the virtual addresses configured in all VRRP groups. vrrp delay minimum Set the delay time for VRRP initialization after an interface comes up. Z-Series, S4810 Syntax Parameters vrrp delay minimum seconds seconds Enter the number of seconds for the delay for VRRP initialization after an interface becomes operational. The range is 0 to 900 (0 indicates no delay). Defaults Command Modes Command History 0 INTERFACE Version 9.0.0.0 Introduced on the Z9000. 1624