Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 1620

Command Modes Command History Usage Information • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For Port Channel interface types, enter the keywords portchannel followed by the number. For the C-Series and SSeries, the range is 1 to 128. For the E-Series, the range is 1 to 255 for TeraScale. • For SONET interfaces, enter the keyword sonet followed by the slot/port information. • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a VLAN interface, enter the keyword vlan followed by the VLAN ID. The VLAN ID range is from 1 to 4094. brief (OPTIONAL) Enter the keyword brief to view a table of information on the VRRP groups on the E-Series. • EXEC • EXEC Privilege Version 8.3.11.1 Version 8.3.7.0 Version 7.6.1.0 Version 7.5.1.0 pre-Version 6.2.1.1 Introduced on the Z9000. Introduced on the S4810. Introduced on the S-Series. Introduced on the C-Series. Introduced on the E-Series. The following describes the show vrrp brief command shown in the Example below. Item Interface Grp Pri Pre Description Lists the interface type, slot and port on which the VRRP group is configured. Displays the VRRP group ID. Displays the priority value assigned to the interface. If the track command is configured to track that interface and the interface is disabled, the cost is subtracted from the priority value assigned to the interface. States whether preempt is enabled on the interface. • Y = Preempt is enabled. • N = Preempt is not enabled. State Displays the operational state of the interface by using one of the following: 1620