Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 911

ipv6 access-group Assign an IPv6 access-group to an interface. C-Series, E-Series, S-Series Syntax ipv6 access-group access-list-name {in | out} [implicit-permit] [vlan range] To delete an IPv6 access-group configuration, use the no ipv6 access-group access-list-name {in} [implicit-permit] [vlan range] command. Parameters access-list-name in | out implicit-permit vlan range Enter the name of a configured access list, up to 140 characters. Enter either the keyword in or out to apply the IPv6 ACL to incoming traffic (ingress) or outgoing traffic (egress). (OPTIONAL) Enter the keywords implicit-permit to change the default action of the IPv6 ACL from implicit-deny to implicit-permit (that is, if the traffic does not match the filters in the IPv6 ACL, the traffic is permitted instead of dropped). (OPTIONAL) Enter the keyword vlan followed by the VLAN range in a comma separated format. The range is 1 to 4094. Defaults Command Modes Command History Disabled. INTERFACE Version 8.4.2.1 Version 7.8.1.0 Version 7.4.1.0 Introduced on the S-Series. Introduced on the C-Series. Increased the name string to accept up to 140 characters. Prior to version 7.8.1.0, names are up to 16 characters long. Introduced on the E-Series TeraScale. Usage Information Example You can assign an IPv6 access group to a physical, LAG, or VLAN interface context. FTOS(conf-if-gi-9/0)#ipv6 access-group AclList1 in implicitpermit vlan 10-20 FTOS(conf-if-gi-9/0)#show config ! interface GigabitEthernet 9/0 no ip address ipv6 access-group AclList1 in implicit-permit Vlan 10-20 no shutdown FTOSconf-if-gi-9/0)# 911