Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 514

neighbor route-map Apply an established route map to either incoming or outbound routes of a BGP neighbor or peer group. C-Series, E-Series Syntax neighbor {ipv6-address | peer-group-name} route-map map-name {in | out} To remove the route map, use the no neighbor {ipv6-address | peer-groupname} route-map map-name {in | out} command. Parameters ipv6-address Enter the IPv6 address in the x:x:x:x::x format. NOTE: The :: notation specifies successive hexadecimal fields of zeros. peer-group-name map-name in out Enter the name of the peer group. Enter the name of an established route map. If you do not configure the Route map, the default is deny (to drop all routes). Enter the keyword in to filter inbound routes. Enter the keyword out to filter outbound routes. Defaults Command Modes Command History Not configured. ROUTER BGPV6-ADDRESS FAMILY Version 8.2.1.0 Version 7.4.1.0 Introduced on the E-Series ExaScale. Introduced Usage Information When you apply a route map to outbound routes, only routes that match at least one section of the route map are permitted. If you identify a peer group by name, the peers in that peer group inherit the characteristics in the Route map used in this command. If you identify a peer by IP address, the Route map overwrites either the inbound or outbound policies on that peer. neighbor route-reflector-client Configure a neighbor as a member of a route reflector cluster. C-Series, E-Series Syntax neighbor {ipv6-address | peer-group-name} route-reflectorclient To indicate that the neighbor is not a route reflector client or to delete a route reflector configuration, use the no neighbor {ipv6-address | peer-group-name} route-reflector-client command. 514