Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 1065

• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet followed by the slot/port information. • For a 1-Gigabit Ethernet interface, enter the keyword GigabitEthernet followed by the slot/port information. • For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by the slot/ port information. Command Modes Command History Usage Information • EXEC • EXEC Privilege Version 8.3.11.1 Version 8.3.12.0 Legacy E-Series command. Introduced on the Z9000. Introduced on the S4810. The following describes the show fefd command shown in the Example below. Field Interface Mode Interval State Description Displays the interfaces type and number. Displays the mode (aggressive or normal) or NA if the interface contains fefd reset in its configuration. Displays the interval between FEFD packets. Displays the state of the interface and can be one of the following: • bi-directional (interface is up and connected and ing neighbor's echoes). • err-disabled (only found when the FEFD mode is aggressive and when the interface has not n its neighbor's echoes for 3 times the message interval. To reset an interface in this state, use the fefd reset command.) • unknown (only found when FEFD mode is normal. • locally disabled (interface contains the fefd reset command in its configuration). • Admin Shutdown (interface is disabled with the shutdown command). Example FTOS#sh fefd FEFD is globally 'ON', interval is 10 seconds, mode is 'Aggressive'. INTERFACE MODE Gi 5/0 Gi 5/1 Gi 5/2 Gi 5/3 Gi 5/4 Aggressive Aggressive Aggressive Aggressive Aggressive INTERVAL (second) 10 10 10 10 10 STATE Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown Admin Shutdown 1065