Dell Force10 S4810P FTOS Command Line Reference Guide for the S4810 System FTO - Page 132

Usage Information Example Related Commands Use this command only to configure an empty slot or a slot in which you have hot-swapped a 4port 40GE line card. Before you insert a different line-card type into a slot pre-configured for a 4-port 40GE line card, be sure to enter the no linecard number command. WARNING: After you enter the linecard command to reconfigure a 4-port 40GE line card installed in an ExaScale switch, you are prompted to reboot the line card to activate the settings. Traffic on the line card is interrupted when you reset the card. On a 4-port 40GE line card, there are six ports and two port pipes (0 and 1). Each port pipe consists of three ports, one CFP port and two QSFP ports: • Ports 0, 1, and 2 use pipe 0. • Ports 3, 4, and 5 use pipe 1. To configure linerate mode, specify one port on each pipe. To configure oversubscribed mode, specify two ports on each pipe. FTOS(conf)# linecard 5 EX04PJ oversubscribed active-ports portset0 1 2 port-set1 0 1 FTOS(conf)# linecard 13 EX04PH linerate active-ports port-set0 2 port-set1 0 FTOS(conf)# linecard 5 EX04PJ linerate active-ports port-set0 1 port-set1 1 Updating the linecard mode or active-ports will require a linecard reboot. Proceed with reset of linecard? [confirm yes/no]: show linecard - displays the line card(s) status. module power-off Turn off power to a line card at next reboot. C-Series, E-Series Syntax Parameters module power-off linecard number linecard number Enter the keyword linecard followed by the line card slot number. The C-Series range is 0 to 7. The E-Series range is 0 to 13 on the E1200/1200i, 0 to 6 on the E600/E600i, and 0 to 5 on the E300. Defaults Command Modes Command History Not configured. CONFIGURATION Version 8.1.1.2 Version 8.1.1.0 Version 7.5.1.0 Introduced on the E-Series ExaScale E600i. Introduced on the E-Series ExaScale E1200i. Introduced on the C-Series. 132