Epson EPL-7000 User Manual - Page 159

Status and Error Messages This chapter supplies solutions to problems you may encounter. If an error occurs, your best source of information is the display on the control panel. The error messages displayed there tell you what is wrong and, in some cases, indicate the actions you should take to correct the problem. Status messages also appear on the display during the printer's normal operation. They indicate the printer's current status. This section contains an alphabetical list of status and error messages you may encounter and includes the steps you need to take to correct any problems. Note: In some cases, the red CONTINUE light flashes when an error is detected. This requires you to correct the problem and then press the CONTINUE button to clear the error. However, if the AUTO CONT option in SelecType is set to ON, some errors may clear automatically even though the problem remains. In most instances, you should leave AUTO CONT set to OFF. Status messages are preceded by [S], warning messages are preceded by [W], and error messages are preceded by [E]. In some cases the message you see on your display also shows the printer mode. [E] ADD MEMORY FOR CH-X The printer has insufficient memory available in the channel displayed. You may have changed the printer mode, increased the RX-BUFFER setting, or changed the MEMORY SHARE setting. To correct the error, add memory. You can also decrease the RX-BUFFER setting or change the MEMORY SHARE setting in SelecType Level 2. 7-2 Troubleshooting