Epson EPL-7000 User Manual - Page 268
Checking the chip set, O side of the switch is down
View all Epson EPL-7000 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 268 highlights
The Memory Chip Set CAUTION: To fit the controller board securely into the printer, make sure the upper tabs on the levers are positioned inside the opening. 3. Now slide the controller board completely into the printer. (The two levers pivot outward as the board locks into place.) If the controller board does not fit smoothly into the printer, do not force it. Remove it and check to see that the edges are set properly into the tracks. 4. Press in on the board gently to make sure that it is seated firmly inside the printer. Then secure the board with the four retaining screws as shown below. 5. Make sure the power is off (the O side of the switch is down); then reconnect the power cord. Checking the chip set Complete the following steps to make sure that the chip set is installed properly and is functioning correctly: A-40 Appendix A