Epson EPL-7000 User Manual - Page 179

Printing Problems Problem The printer does not print or stops printing. Solution The ON LINE light is on but nothing is printed. The interface cable may not be plugged in securely. Check both ends of the cable between the printer and the computer. If you are using a parallel interface, secure the connector using the wire retaining clips. You may not be using the correct interface cable. Make sure that your interface cable meets the specifications for the printer and computer. You may not have selected the correct interface settings with SelecType. Select the appropriate interface (serial or parallel). If you are using a serial interface, also set the baud rate, protocol, data bit, and related settings. See your computer manual for the correct settings and interface requirements. The software may not be installed properly for your printer. Use the program's setup (or install) procedure to check the printer settings on your computer's display; then reset the values correctly. Make sure the SelecType operating mode (L-JET2P, FX, or LQ) matches your program's printer driver. See Chapter 5. 7-22 Troubleshooting