HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Services Conf - Page 148
Create interface Tunnel 1., Reference service loopback group 1 on the tunnel.
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 148 highlights
# Configure an IPv4 address for VLAN-interface 101 (configured on the physical interface of the tunnel). [SwitchA] interface vlan-interface 101 [SwitchA-Vlan-interface101] ip address 2.1.1.1 255.255.255.0 [SwitchA-Vlan-interface101] quit # Create service loopback group 1 to support the tunnel service. [SwitchA] service-loopback group 1 type tunnel # Assign GigabitEthernet 1/0/3 to service loopback group 1, and disable STP, and LLDP on the interface. [SwitchA] interface GigabitEthernet 1/0/3 [SwitchA-GigabitEthernet1/0/3] undo stp enable [SwitchA-GigabitEthernet1/0/3] undo lldp enable [SwitchA-GigabitEthernet1/0/3] port service-loopback group 1 [SwitchA-GigabitEthernet1/0/3] quit # Create interface Tunnel 1. [SwitchA] interface tunnel 1 # Configure an IPv4 address for interface Tunnel 1. [SwitchA-Tunnel1] ip address 10.1.2.1 255.255.255.0 # Configure the tunnel encapsulation mode. [SwitchA-Tunnel1] tunnel-protocol ipv4-ipv4 # Configure a source address for interface Tunnel 1 (IP address of VLAN-interface 101). [SwitchA-Tunnel1] source 2.1.1.1 # Configure a destination address for interface Tunnel 1 (IP address of VLAN-interface 101 of Switch B). [SwitchA-Tunnel1] destination 3.1.1.1 [SwitchA-Tunnel1] quit # Reference service loopback group 1 on the tunnel. [SwitchA-Tunnel1] service-loopback-group 1 [SwitchA-Tunnel1] quit # Configure a static route from Switch through interface Tunnel 1 to Group 2. [SwitchA] ip route-static 10.1.3.0 255.255.255.0 tunnel 1 • Configure Switch B: # Configure an IPv4 address for VLAN-interface 100. system-view [SwitchB] interface vlan-interface 100 [SwitchB-Vlan-interface100] ip address 10.1.3.1 255.255.255.0 [SwitchB-Vlan-interface100] quit # Configure an IPv4 address for VLAN-interface 101 (the physical interface of the tunnel). [SwitchB] interface vlan-interface 101 [SwitchB-Vlan-interface101] ip address 3.1.1.1 255.255.255.0 [SwitchB-Vlan-interface101] quit # Create service loopback group 1 to support the tunnel service. [SwitchB] service-loopback group 1 type tunnel # Assign GigabitEthernet 1/0/3 to service loopback group 1, and disable STP, and LLDP on the interface. 140