HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Services Conf - Page 158
Con the tunnel encapsulation mode., Con an IPv6 address for interface Tunnel 2.
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
[SwitchB] interface tunnel 2 # Configure an IPv6 address for interface Tunnel 2. [SwitchB-Tunnel2] ipv6 address 3001::1:2 64 # Configure the tunnel encapsulation mode. [SwitchB-Tunnel2] tunnel-protocol ipv6-ipv6 # Configure the source address for interface Tunnel 2 (IP address of VLAN-interface 101) [SwitchB-Tunnel2] source 2002::22:1 # Configure the destination address for interface Tunnel 2 (IP address of VLAN-interface 101 of Switch A). [SwitchB-Tunnel2] destination 2002::11:1 # Reference service loopback group 1 on the tunnel. [SwitchB-Tunnel2] service-loopback-group 1 [SwitchB-Tunnel2] quit # Configure a static route from Switch B through interface Tunnel 2 to Group 1. [SwitchB] ipv6 route-static 2002:1:: 64 tunnel 2 Verifying the configuration Display the status of the tunnel interfaces on Switch A and Switch B. [SwitchA] display ipv6 interface tunnel 1 Tunnel1 current state :UP Line protocol current state :UP IPv6 is enabled, link-local address is FE80::2013:1 Global unicast address(es): 3001::1:1, subnet is 3001::/64 Joined group address(es): FF02::1:FF13:1 FF02::1:FF01:1 FF02::1:FF00:0 FF02::2 FF02::1 MTU is 1460 bytes ND reachable time is 30000 milliseconds ND retransmit interval is 1000 milliseconds Hosts use stateless autoconfig for addresses IPv6 Packet statistics: ... [SwitchB] display ipv6 interface tunnel 2 Tunnel2 current state :UP Line protocol current state :UP IPv6 is enabled, link-local address is FE80::2024:1 Global unicast address(es): 3001::1:2, subnet is 3001::/64 Joined group address(es): FF02::1:FF24:1 FF02::1:FF01:2 FF02::1:FF00:0 FF02::2 150