HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Services Conf - Page 153
Reference service loopback group 1 on the tunnel.
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
# Create service loopback group 1 to support the tunnel service. [SwitchB] service-loopback group 1 type tunnel # Assign GigabitEthernet 1/0/3 to service loopback group 1, and disable STP, and LLDP on the interface. [SwitchB] interface GigabitEthernet 1/0/3 [SwitchB-GigabitEthernet1/0/3] undo stp enable [SwitchB-GigabitEthernet1/0/3] undo lldp enable [SwitchB-GigabitEthernet1/0/3] port service-loopback group 1 [SwitchB-GigabitEthernet1/0/3] quit # Create interface Tunnel 2. [SwitchB] interface tunnel 2 # Configure an IPv4 address for interface Tunnel 2. [SwitchB-Tunnel2] ip address 30.1.2.2 255.255.255.0 # Configure the tunnel encapsulation mode. [SwitchB-Tunnel2] tunnel-protocol ipv4-ipv6 # Configure the source address for interface Tunnel 2 (IP address of VLAN-interface 101). [SwitchB-Tunnel2] source 2002::2:1 # Configure the destination address for interface Tunnel 2 (IP address of VLAN-interface 101 of Switch A). [SwitchB-Tunnel2] destination 2002::1:1 # Reference service loopback group 1 on the tunnel. [SwitchB-Tunnel2] service-loopback-group 1 [SwitchB-Tunnel2] quit # Configure a static route from Switch B through interface Tunnel 2 to Group 1. [SwitchB] ip route-static 30.1.1.0 255.255.255.0 tunnel 2 Verifying the configuration Display the status of the tunnel interfaces on Switch A and Switch B. [SwitchA] display interface tunnel 1 Tunnel1 current state: UP Line protocol current state: UP Description: Tunnel1 Interface The Maximum Transmit Unit is 1460 Internet Address is 30.1.2.1/24 Primary Encapsulation is TUNNEL, service-loopback-group ID is 1. Tunnel source 2002::0001:0001, destination 2002::0002:0001 Tunnel bandwidth 64 (kbps) Tunnel protocol/transport IP/IPv6 Last 300 seconds input: 0 bytes/sec, 0 packets/sec Last 300 seconds output: 0 bytes/sec, 0 packets/sec 152 packets input, 9728 bytes 0 input error 168 packets output, 10752 bytes 0 output error [SwitchB] display interface tunnel 2 Tunnel2 current state: UP 145