HP 6125G HP 6125G & 6125G/XG Blade Switches Layer 3 - IP Services Conf - Page 157
Assign GigabitEthernet 1/0/3 to service loopback group 1, and disable STP, and LLDP on
View all HP 6125G manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 157 highlights
# Assign GigabitEthernet 1/0/3 to service loopback group 1, and disable STP, and LLDP on the interface. [SwitchA] interface GigabitEthernet 1/0/3 [SwitchA-GigabitEthernet1/0/3] undo stp enable [SwitchA-GigabitEthernet1/0/3] undo lldp enable [SwitchA-GigabitEthernet1/0/3] port service-loopback group 1 [SwitchA-GigabitEthernet1/0/3] quit # Create interface Tunnel 1. [SwitchA] interface tunnel 1 # Configure an IPv6 address for interface Tunnel 1. [SwitchA-Tunnel1] ipv6 address 3001::1:1 64 # Configure the tunnel encapsulation mode. [SwitchA-Tunnel1] tunnel-protocol ipv6-ipv6 # Configure the source address for interface Tunnel 1 (IP address of VLAN-interface 101). [SwitchA-Tunnel1] source 2002:11::1 # Configure the destination address for interface Tunnel 1 (IP address of VLAN-interface 101 of Switch B). [SwitchA-Tunnel1] destination 2002::22:1 # Reference service loopback group 1 on the tunnel. [SwitchA-Tunnel1] service-loopback-group 1 [SwitchA-Tunnel1] quit # Configure a static route from Switch A through interface Tunnel 1 to Group 2. [SwitchA] ipv6 route-static 2002:3:: 64 tunnel 1 • Configure Switch B: # Enable IPv6. system-view [SwitchB] ipv6 # Configure an IPv6 address for VLAN-interface 100. [SwitchB] interface vlan-interface 100 [SwitchB-Vlan-interface100] ipv6 address 2002:3::1 64 [SwitchB-Vlan-interface100] quit # Configure an IPv6 address for VLAN-interface 101 (the physical interface of the tunnel). [SwitchB] interface vlan-interface 101 [SwitchB-Vlan-interface101] ipv6 address 2002::22:1 64 [SwitchB-Vlan-interface101] quit # Create service loopback group 1 to support the tunnel service. [SwitchB] service-loopback group 1 type tunnel # Assign GigabitEthernet 1/0/3 to service loopback group 1, and disable STP, and LLDP on the interface. [SwitchB] interface GigabitEthernet 1/0/3 [SwitchB-GigabitEthernet1/0/3] undo stp enable [SwitchB-GigabitEthernet1/0/3] undo lldp enable [SwitchB-GigabitEthernet1/0/3] port service-loopback group 1 [SwitchB-GigabitEthernet1/0/3] quit # Create interface Tunnel 2. 149