HP Dc7700 HP Compaq dx7300 and dc7700 Business PC Technical Reference Guide, 1 - Page 157

Error Messages and Codes A.4 System Error Messages (1xx-xx) Table A-3. System Error Messages Message Probable Cause Message Probable Cause 101 Option ROM error 109-02 CMOS clock rollover test failed 102 System board failure [1] 109-03 CMOS not properly initialized (clk test) 103 System board failure 110-01 Programmable timer load data test failed 104-01 Master int. cntlr. test fialed 110-02 Programmable timer dynamic test failed 104-02 Slave int. cntlr. test failed 110-03 Program timer 2 load data test failed 104-03 Int. cntlr. SW RTC inoperative 111-01 Refresh detect test failed 105-01 Port 61 bit not at zero 112-01 Speed test Slow mode out of range 105-02 Port 61 bit not at zero 112-02 Speed test Mixed mode out of range 105-03 Port 61 bit not at zero 112-03 Speed test Fast mode out of range 105-04 Port 61 bit not at zero 112-04 Speed test unable to enter Slow mode 105-05 Port 61 bit not at zero 112-05 Speed test unable to enter Mixed mode 105-06 Port 61 bit not at one 112-06 Speed test unable to enter Fast mode 105-07 Port 61 bit not at one 112-07 Speed test system error 105-08 Port 61 bit not at one 112-08 Unable to enter Auto mode in speed test 105-09 Port 61 bit not at one 112-09 Unable to enter High mode in speed test 105-10 Port 61 I/O test failed 112-10 Speed test High mode out of range 105-11 Port 61 bit not at zero 112-11 Speed test Auto mode out of range 105-12 Port 61 bit not at zero 112-12 Speed test variable speed mode inop. 105-13 No int. generated by failsafe timer 113-01 Protected mode test failed 105-14 NMI not triggered by failsafe timer 114-01 Speaker test failed 106-01 Keyboard controller test failed 116-xx Way 0 read/write test failed 107-01 CMOS RAM test failed 162-xx Sys. options failed (mismatch in drive type) 108-02 CMOS interrupt test failed 163-xx Time and date not set 108-03 CMOS not properly initialized (int.test) 164-xx Memory size 109-01 CMOS clock load data test failed 199-00 Installed devices test failed NOTES: [1] 102 message code may be caused by one of a variety of processor-related problems that may be solved by replacing the processor, although system board replacement may be needed. Technical Reference Guide www.hp.com A-5