HP LaserJet 3200 Service Manual - Page 110
Upper guide assembly, Upper guide assembly removal 1 of 4
View all HP LaserJet 3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 110 highlights
Upper guide assembly 1 Remove the DIMMs, the back, right, and left covers, the internal paper guide, the top cover, the printer door, and the document scanner assembly (see pages 89 through 102). 2 If you have not already done so, disconnect the motor cable. 3 Place the upper guide assembly and contact image sensor assembly at approximately a 90-degree angle, and then lift the upper guide assembly off of its hinges. 4 Remove two screws (callout 1), one on each side of the upper guide assembly. 12 Figure 36. Upper guide assembly removal (1 of 4) 108 Chapter 5 - Removal and replacement EN
108
Chapter 5 - Removal and replacement
EN
Upper guide assembly
1
Remove the DIMMs, the back, right, and left covers, the internal
paper guide, the top cover, the printer door, and the document
scanner assembly (see pages 89 through 102).
2
If you have not already done so, disconnect the motor cable.
3
Place the upper guide assembly and contact image sensor
assembly at approximately a 90-degree angle, and then lift the
upper guide assembly off of its hinges.
4
Remove two screws (callout 1), one on each side of the upper
guide assembly.
Figure 36.
Upper guide assembly removal (1 of 4)
2
1