HP LaserJet 3200 Service Manual - Page 197
Table 19., Fax send error codes continued
View all HP LaserJet 3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 197 highlights
Table 19. Fax send error codes (continued) Error code 319 320 321 322 - 324 325 - 328 (ECM error) 329 - 331 332 - 343 Error condition Solution The local machine has attempted to 1 initiate a binary file transfer (BFT) but has detected that the remote machine 2 does not support this mode of operation. Enable the BFT capability on the remote machine if it is supported. Retransmit the document as a normal fax, rather than attempting a BFT transfer. The local machine is set up to initiate poll reception with a remote machine, but it has detected that the remote machine is not configured to do this. Poll transmission from a remote machine is typically configured on a session by session basis. Confirm that the local user really wants to attempt a poll reception. If not, reconfigure the local machine for a normal fax transmission. -OrConfigure the remote machine for poll transmission. The remote user must load a document to transmit and then configure the machine for polling. There was a communication error with the receiving fax machine caused by poor telephone line conditions. Reattempt the fax transmission at a different time when telephone line conditions have improved. Telephone line conditions were too poor 1 to send a fax. Reattempt the fax transmission at a different time when telephone line conditions have improved. 2 If the session fails after transmitting several pages of a large document, retransmit the document as several smaller documents. Telephone line conditions were very poor. Reattempt the fax transmission at a different time when telephone line conditions have improved. -OrDisable ECM. Errors may still occur, and may result in a degraded image quality on the received page. However, the ability to transmit the entire document will be improved. The remote machine has reported that one or more pages have been received (non-ECM mode) with excessive errors. This error does not result in the session being terminated immediately. Subsequent page transmission can still occur and later pages may be received without error. Reattempt the fax transmission at a different time when telephone line conditions have improved. -OrSelect a lower speed for the initial transmission speed. There is a defect in the remote fax machine (the other machine) and there is no solution except to send or receive to or from another fax machine. EN Troubleshooting tools 195