HP LaserJet 3200 Service Manual - Page 42
No Fax S In, No Dial Tone.
View all HP LaserJet 3200 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 42 highlights
Table 7. Control panel error messages (continued) Message MEMORY LOW. ONLY 1 COPY. PRESS [STOP] MEMORY LOW. [STOP] TO CANCEL. NO DIAL TONE. NO DOCUMENT SENT NO FAX DETECTED NO FAX PAGES IN MEMORY TO REPRINT NOT ENOUGH MEMORY. TRY AGAIN LATER Cause The product completed making one copy. The remaining copies have been canceled because of low product memory. The product memory has been almost completely filled. The product could not detect a dial tone. The fax forwarding setting is on and the product unsuccessfully received a fax because of low memory or some other reason. The product deleted the incomplete received data before attempting to forward the deleted data. The product answered the incoming call but could not determine that the caller was a fax machine. The product attempted to execute "Reprint Last Fax" when nothing was in memory. There is not enough memory to start a new job. Solution Press STOP/CLEAR to clear the error. Use the HP LaserJet Director to make multiple copies of large documents, or break the job into smaller jobs containing fewer pages. Allow the product to finish the job or press STOP/CLEAR to cancel the job. Unplug the telephone cord from both the product and the wall and replug the cord. Unplug the product telephone cord from the wall, plug in a telephone, and try making a call. Plug the product phone cord into a jack for another phone line. See "Changing the detect dial tone setting" in the online user guide. Also see chapter 6, "Troubleshooting." Print the faxes in memory and have the sender resend the missing page(s) of the document. Allow the product to retry sending the fax. Unplug the product telephone cord from the wall, plug in a telephone, and try making a call. Plug the product phone cord into a jack for another phone line. See chapter 6, "Troubleshooting." Receive a fax before attempting to use this option. Wait until the current job is finished before starting a new job. 40 Chapter 2 - Installation and operation EN