HP LaserJet 3200 Service Manual - Page 194

Table 18. Fax receive error codes (continued) Error code 247 - 251 252 253 281 282 283 284 285 Error definition The remote machine appears to be stuck "on." Telephone line conditions were too poor to receive a fax. The remote machine has attempted to initiate a page transmission using a page width that is not supported by the local machine. The local machine has not received any data at the start of a page during nonECM reception although the modem has not detected a remote disconnect. The remote machine is probably transmitting fill bytes instead of data and is either broken or jammed. The local machine has not received any data at the start of a page during ECM reception although the modem has not detected a remote disconnect. The remote machine is probably transmitting sync frames instead of data and is either broken or jammed. The local machine has detected that modem carrier has stopped. Either the line has been disconnected or the remote machine has aborted the transmission. The local machine has not received any data during non-ECM page reception and a timeout failure has occurred. The remote machine is probably transmitting fill bytes instead of data and is either broken or jammed. The local machine has stopped receiving any data during an ECM page reception although the modem has not detected a remote disconnect. The remote machine is probably transmitting sync frames instead of data and is either broken or jammed. Solution None. 1 Reattempt the fax reception at a later time when line conditions may have improved. 2 Configure the machine to start reception at a lower speed. 3 If the local machine received successfully several pages of a larger document, ask the remote user to transmit the document in several smaller parts. Ask the remote user to reconfigure their fax machine to transmit using a "normal" (letter/A4 page width). Reattempt the fax reception after first requesting that the remote user check his or her machine. Reattempt the fax reception after first requesting that the remote user check his or her machine. Reattempt the fax reception after first requesting that the remote user check his or her machine. Reattempt the fax reception after first requesting that the remote user check his or her machine. Reattempt the fax reception after first requesting that the remote user check his or her machine 192 Chapter 6 - Troubleshooting EN