HP LaserJet 3200 Service Manual - Page 198

Table 19. Fax send error codes (continued) Error code 344 - 348 349-353 (ECM error) 354-355 356 - 361 362-366 (ECM error) 367 - 372 373-377 (ECM error) 378-379 380 381 382 Error condition Solution The remote machine has failed to 1 respond to a fax command from the local machine because the connection is interrupted. 2 -Or- The remote user has pressed the Stop key while the reception was in progress -Or- Under rare conditions incompatibility between the two machines may cause the remote machine to simply abandon the call. Reattempt the fax transmission at a different time when telephone line conditions have improved. If the fax session was using error correction, disable ECM. The remote user has pressed the Stop 1 key causing the session to be aborted. -Or- The remote machine has encountered a system problem such as no paper or a paper jam which has inhibited it from 2 receiving any more pages, and which has caused it to terminate the session prematurely. -Or- A feature incompatibility has been encountered by the remote machine causing it to terminate the session. Configure the remote machine for document reception by clearing any paper jams, loading sufficient paper, and clearing any other system errors. Configure the local fax machine to use different configurations; toggle the ECM state; select a slower reception speed. The remote machine appears to be stuck None. "on." The remote machine has failed to issue a valid response to a CTC frame. This occurs during ECM transmission after multiple retransmissions of erroneous data. The remote machine has failed to respond to a fax command from the local machine because the connection is interrupted. -OrThe remote user has pressed the Stop key while the reception was in progress. The remote fax machine has been "holding off" the local fax machine from continuing the on-going transmission because of a temporary low memory condition at the remote machine. If this "hold off" period exceeds a machine's specific timeout value, the session will be terminated. None; there is a defect in the remote machine. 1 Reattempt the fax transmission at a different time when telephone line conditions have improved. 2 Disable ECM. Resend the document as two or more separate fax transmissions. Wait several minutes between the end of one transmission and the start of the next transmission. -OrDisable ECM. 196 Chapter 6 - Troubleshooting EN