HP Surestore Disk Array FC60 HP SureStore E Disk Array 12H User's and Service - Page 191
Removal and Replacement, Tools Required
View all HP Surestore Disk Array FC60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 191 highlights
Chapter 7. Removal and Replacement This chapter provides detailed instructions for enclosure parts removal and replacement. This chapter also describes and identifies part numbers. WARNING! The procedures in this chapter should only be performed by a qualified service representative. If you are not a qualified service representative, performing these procedures may result in personal injury or loss of data. CAUTION! Check with system administrator before powering down the system. Tools Required • T-15 (TORX) driver • T-20 (TORX) driver • T-25 (TORX) driver • Standard flat-bladed screwdriver • Small flat-bladed screwdriver (less than 4 inches long and less than 0.25 inch width) • 3/8-inch nut driver • 19-mm deep socket • 5-mm nut driver • Needle-nosed pliers Replacing a Failed Controller Module-HP-qualified personnel only Replacement controller modules are shipped without batteries. Therefore, if you are installing a replacement controller, you should remove and use the good battery packs from the controller module being replaced. 191 Removal