HP Surestore Disk Array FC60 HP SureStore E Disk Array 12H User's and Service - Page 194
Display ModuleŒHP-qualified personnel only, Remove the two T-15 M4 Screws
View all HP Surestore Disk Array FC60 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
Removal and Replacement Display Module-HP-qualified personnel only Display Module-HP-qualified personnel only CAUTION! The following procedures require that you perform a shutdown, turn off the disk array, and make it inaccessible. Check with the system administrator before proceeding. To replace the display module(see Figure 32): 1. Shut down the disk array, turn off the disk array, disconnect the ac power cords and SCSI interface cables. 2. Remove the two captive screws from the rear cover. Tilt back the top of the rear cover and remove it completely. 3. Remove the two T-15 M4 Screws (Figure 32, Item 3) that secure the display module to the backplane assembly. 4. Remove both controller modules from the enclosure. 5. Remove the display module from the front of the disk array. 194 Removal