Panasonic WJSX650 WJSX650 User Guide - Page 52
System, Data Port, Serial Port, Vd2/data/cable Compensation, Rs485 Camera, Comm.
View all Panasonic WJSX650 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 52 highlights
I SYSTEM You will perform the system settings required to transmit data between the unit and connected devices. When you select SYSTEM on the top menu, the following menu is displayed. 500 SYSTEM 510 DATA PORTO 520 SERIAL PORT BCOMMUNICATION STATUS (8/ NONE/1) 38400 530 VD2/DATA/CABLE COMPENSATIONO 540 RS485 CAMERAO G SYSTEM Menu • DATA PORT DATA PORT menu will be displayed. You will select the DATA port types according to the connected devices. • SERIAL PORT Select the communication speed of SERIAL port. (The factory default is 38 400 bps.) 4 800 bps/9 600 bps/19 200 bps/38 400 bps Other parameters (COMMUNICATION STATUS) are as follows. (Setting change is not available.) Data bit: 8 (bits) Parity check: NONE Stop bit: 1 (bit) • VD2/DATA/CABLE COMPENSATION VD2/DATA/CABLE COMPENSATION menu is displayed. You will perform the settings for VD2, camera control signal (DATA), and cable compensation. • RS485 CAMERA RS485 CAMERA menu is displayed. You will set the RS-485 port numbers and unit numbers for the RS-485 cameras. G DATA PORT Menu 510 DATA PORT OUTPUT BOARD1 OUTPUT BOARD2 DATA 1 2 3 4 5 6 7 8 TYPE TMNL1 PSD HDR1 HDR2 TMNL5 TMNL6 HDR3 HDR4 COMM. 9600 9600 9600 9600 9600 9600 19200 19200 COMMUNICATION STATUS DATA=DATA(TMNL/PCD/HDR) 8/ NONE/1 • TYPE Select the DATA port types according to the connected devices. TMNL1 to 8: Select this when using the DATA port for sys- tem controller in the terminal mode. PSD: Select this when using the DATA port for system con- troller in the PS·Data mode. HDR1 to 4: Select this when connecting a recorder to the DATA port. The available port settings are as follows. DATA1: TMNL1 /PSD (The factory default is TMNL1.) DATA2: TMNL2 (The factory default is TMNL2.) DATA3: TMNL3/HDR1 (The factory default is HDR1.) DATA4: TMNL4/HDR2 (The factory default is HDR2.) DATA5: TMNL5 (The factory default is TMNL5.) DATA6: TMNL6 (The factory default is TMNL6.) DATA7: TMNL7/ HDR3 (The factory default is HDR3.) DATA8: TMNL8/ HDR4 (The factory default is HDR4.) • COMM. Select the communication speed. (The factory default is 9 600 bps.) 4 800 bps/9 600 bps/19 200 bps Parameters of COMMUNICATION STATUS are as follows. (Setting change is not available.) Data bit: 8 (bits) Parity check: NONE Stop bit: 1 (bit) Note: When changing the communication speed, conform the communication speed settings to that of the connected devices. 52