Panasonic WJSX650 WJSX650 User Guide - Page 66

Alarm Descriptions I Alarm Occurrence When this unit accept an alarm input signal (terminal alarm, camera alarm, recorder alarm, serial alarm, or video loss), an alarm event (tour sequence, etc.) is activated automatically. Each alarm input signal is associated with an alarm event setting. (The setting activates the alarm input signal and alarm event.) Up to 1 024 alarm event settings are available. The alarm event setting is performed in "Alarm" - "Alarm Event" of WJ-SX650 Series Administrator Console. By performing the settings of "Alarm Event", the following events will be activated when this unit accepts an alarm input signal. • Alarm event information will be displayed on the associated monitors (Refer to p. 13 Monitor Display Information.) • Depending on the setting of "Display Mode", camera images will be displayed, or sequences will be activated on the associated monitors. In this document, these actions are mentioned as the alarm mode, and pictures displayed during the alarm mode is mentioned as alarm pictures. • Depending on the setting of "Recording Source (LCN)", event recording will be activated. (Recording will follow the command alarm setting and event recording setting of recorder. Refer to the operating instructions of recorder for details.) • Depending on the setting of "Alarm Output", alarm output signal will be supplied from the video output board, and external alarm devices (buzzer, etc.) can be activated. Notes: • To activate alarm output signals from the ALARM OUT 1/2 port, perform settings of No.1 to 64. No.65 and greater are assigned for serial commands. • To activate alarm output signals as a serial command, serial command settings are required. The settings are performed in "Communication" - "Serial Command" of WJ-SX650 Series Administrator Console. • ALARM indicators of all system controllers blink. • Up to 10 000 alarm records are saved chronologically. The latest 1 000 alarm records can be displayed as the alarm history on the monitor. (Refer to p. 69 Alarm History Display.) The Alarm History can be downloaded from the PC to the unit. • Alarm information is notified to the PC in serial commands. The serial command setting is performed in "Communication" - "Serial Command" of WJ-SX650 Series Administrator Console. Camera 100 This unit Alarm Output 50 Preset Position 1 (Zooming in No.1 (Entrance)) Terminal Alarm 256 650 Matrix Switcher WJ-SX Monitor 5 No.1 (Entrance) Alarm input signal from a sensor Records the image of Camera 100. (Recording follows the command alarm setting and event recording setting of recorder.) ALARM ALARM SUSPEND OPERATE TIMER ERROR ALARM RESET HDD 1 HDD 2 MONITOR1 MONITOR2 1234 STOP PLAY PAUSE REC - REC STOP REV FWD PAN/ GOTO SHIFT SEQ OSD TILT LAST SEARCH 5 6 7 8 ZOOM/ PAN/TILT A-B SLOW SETUP /ESC FOCUS REPEAT - + DISK SELECT COPY TEXT MARK 9 10/0 11 12 IRIS LISTED EL-ZOOM LOGOUT PRESET 13 14 15 16 /AUTO SET BUSY PULL Digital Disk Recorder WJ-HD Recorder 1 Notifies the alarm event PC occurrence. No.11(Dish) No.10 (Pot) Infrared sensor Alarm Input 256 Sensor system Terminal alarm setting No. Display Mode 256 SPOT LCN 100 Spot Preset 1 Monitor 5 Recording Source (LCN) 100 Alarm Output 50 66