Sharp AR-M237 AR-M237 AR-M277 Operation Manual Suite - Page 127

ORIGINALS ORIGINALS THAT CAN BE FAXED Original sizes Using the RSPF Using the document glass Minimum original size 8-1/2" (width) x 5-1/2" (length) (210 mm (width) x 148 mm (length)) 5-1/2" (width) x 8-1/2" (length) (148 mm (width) x 210 mm (length)) Maximum original size 11" (width) x 39.3"* (length) (297 mm (width) x 1000 mm (length)) * Long originals can be loaded. 11" (width) x 17" (length) (297 mm (width) x 420 mm (length)) 1 Note • Originals that are not a standard size (5-1/2" x 8-1/2", 5-1/2" x 8-1/2"R, 8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 14", 11" x 17") can also be faxed. • There are restrictions on originals that can be scanned using the RSPF. See "POINTS TO NOTE WHEN MAKING COPIES" in the operation manual for copier. *Long originals Depending on the resolution setting and the width of the original, there may not be sufficient space in memory to hold a long original. In this case, refer to the following table and select a lower resolution setting and/or shorten the original. Standard Fine Super fine Ultra fine 11" wide 39.3" (1000 mm) 39.3" (1000 mm) 39.3" (1000 mm) 34.6" (880 mm) 8-1/2" wide 39.3" (1000 mm) 39.3" (1000 mm) 39.3" (1000 mm) 39.3" (1000 mm) (unit : inch) Scanning area of original Note that the edges of an original cannot be scanned. Area that cannot be scanned : 0.2" (5 mm) or less at top edge and 0.2" (5 mm) or less at bottom edge : Near edge + far edge = 0.24" (6 mm) or less Top edge Far edge Bottom edge Area that cannot Near edge be scanned Automatic reduction of faxed document If the width of the faxed document is greater than the receiving machine's maximum receivable width, the document will be automatically reduced. Faxed document width 11" x 17" 11" x 17" 8-1/2" x 14" Receiving machine's paper width 8-1/2" x 14" 8-1/2" x 11" 8-1/2" x 11" Reduced size 8-1/2" x 14" 8-1/2" x 11"R 8-1/2" x 11"R Ratio 1 : 0.70 (Area ratio) 1 : 0.5 (Area ratio) 1 : 0.64 (Area ratio) A document can also be faxed without reducing its size. In this case, the left and right edges will not be transmitted. ("AUTO RECEIVE REDUCE SETTING" (p.101)) 9