Sharp AR-M237 AR-M237 AR-M277 Operation Manual Suite - Page 56
Job Program Memory
View all Sharp AR-M237 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 56 highlights
JOB PROGRAM MEMORY If you frequently use the same settings for copy jobs, you can store in the settings in a job program. Up to 10 job programs can be stored, and the programs are retained even when the power is turned off. By storing frequently used copy settings in a program, you can eliminate the bother of selecting the settings each time you use them for a copy job. G After a job program is stored, if any settings of the key operator programs related to the stored job program are prohibited, the related settings in the job program will not be recalled. G If the overwriting of job programs is prohibited in the key operator programs, it will not be possible to overwrite or delete a job program. G To exit job program memory mode, press the [CLEAR ALL] key ( ) on the operation panel or touch the [EXIT] key on the touch panel. STORING A JOB PROGRAM 1 Press the [ ] key. S ACC.#-C 4 Select the copy settings that you wish to store in the program. TO STORE, MAKE SELECTIONS AND PRESS [OK], TO DELETE, PRESS [CANCEL]. The number of copies cannot be stored. SPECIAL MODES 2-SIDED COPY OUTPUT 8½x11 8½x14 2 Touch the [STORE/DELETE] key. NUMBER. ECALL STORE/DELETE 5 Touch the [OK] key. D PRESS EL]. 8½x11 8½x14 CANCEL OK 8½x11 AUTO EXPOSURE AUTO 8½x11 PAPER SELECT 100% COPY RATIO The selected settings will be stored under the program number selected in step 3. 3 Touch a program number from 1 to 10 in the storage register screen. ROGRAMS SS PROGRAM NUMBER. RECALL STORE Note If a numeric key is selected that has already been programmed, a confirmation screen will appear. To replace the existing program with the new program, touch the [STORE] key and continue from step 4. If you do not wish to replace the existing program, touch the [CANCEL] key to return to the above screen and select a different numeric key. 54