Sharp AR-M237 AR-M237 AR-M277 Operation Manual Suite - Page 19

BEFORE USING THE MACHINE LOADING PAPER Make sure that the machine is not copying, printing, or printing a received fax, and then follow these steps to load paper. Loading the paper in the paper tray 1 Pull out the paper tray until it stops. 5 Load paper in the tray. If you are loading the same size of paper as was loaded previously, go to step 4. If you are loading a different size of paper, continue with the following step. Maximum height line 1 2 Squeeze the lock lever of the front guide and slide the front guide to match the width of the paper. Front guide Left guide 3 Move the left guide to the appropriate slot as marked on the tray. When using 11" x 17" copy paper, store the left guide in the slot at the left front of the paper tray. Note • Load the paper with the print side facing up. • Insert the paper along the guides. • The tray holds up to 500 sheets of 21 lb. (80g/m2) bond paper. • Do not load paper above the maximum height line. • When adding paper, first remove any paper remaining in the tray, combine it with the paper to be added, and then reload as a single stack. 6 Push the paper tray firmly back into the machine. 4 Fan the copy paper. If you loaded a different size of paper that was loaded previously, place the appropriate paper size card in the front of the paper tray to indicate the new paper size. Paper size card Paper size card 81/2X11 R 81/2X14 EXTRA 81/2X13 51/2X81/2 A4 11X17 81/2X11 Note If you loaded a different size of paper that was loaded previously, go to "CHANGING A TRAY'S PAPER TYPE AND PAPER SIZE SETTINGS" (p.19). 17