Sharp AR-M237 AR-M237 AR-M277 Operation Manual Suite - Page 174

TRANSMISSION USING F-CODES PROCEDURE FOR F-CODE POLLING Make sure that a document has not been placed in the RSPF or on the document glass, and then follow the steps below. Note • You must know the sub-address (SEP) and passcode (PWD) of the other machine's F-code polling memory box. • Serial polling (selecting multiple fax machines to be polled using a group key or by touching the [NEXT ADDRESS] key) is not possible with F-code polling. 1 In fax mode, touch the [SPECIAL MODES] key and then the [POLLING] key. SUB ADDRESS If the address book screen appears, touch SPECIAL MODES ADDRESS REVIEW the [CONDITION DIRECT TX POLLING SETTINGS] key to display the condition DUAL PAGE SCAN PROGRAM settings screen. (p.7) The [POLLING] key is highlighted and the polling icon is displayed. To cancel the polling selection, press the [POLLING] key once again so that it is no longer highlighted. 2 Touch the [OK] key. You will return to the OK condition settings screen. 1/2 SCAN MODE 3 Enter the fax number, sub-address, and passcode of the other fax machine. To use a rapid key, touch the [ADDRESS BOOK] P key to display the CORPO. TPS address book screen. HARP CORPORATION ACC.#-C SHARP GROUP See "ENTERING A SUB-ADDRESS AND PASSCODE FOR A MEMORY BOX IN THE OTHER MACHINE" on page 53 for the procedure for entering sub-addresses and passcodes. 4 Press the [START] key ( ). "JOB STORED." appears on the screen. After communicating with the other machine, your machine prints the received document. To cancel the operation Note Press the [JOB STATUS] key and then cancel the operation as explained on page 24. Only one F-code polling operation with a timer setting (p.30) can be stored. 56