Sharp AR-M237 AR-M237 AR-M277 Operation Manual Suite - Page 24
Normal Copying
View all Sharp AR-M237 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 24 highlights
NORMAL COPYING COPYING FROM THE DOCUMENT GLASS Note If "AUDITING MODE" (p.56) has been enabled, enter your 5-digit account number. 1 Open the RSPF and place the original face down on the document glass. [How to place the original] Align the corner or the original with the tip of the arrow ( ) at the left rear corner of the glass as shown in the illustration. Original scale Original scale 5-1/2" x 8-1/2" 8-1/2" x 14" 8-1/2" x 11" 11" x 17" 8-1/2" x 11" R 2 Close the RSPF. The original size appears in the touch panel. Note • To load paper, see "LOADING PAPER" (p.15). If you change the paper size in the tray, you will also need to change the tray's paper size and paper type settings. (p.19) • The paper types for the auto paper selection function can be selected, or the function disabled, in the key operator programs. (See the "Key operator's guide".) Manually selecting the paper size (paper tray) If auto paper selection is disabled in the key operator programs, or if you wish to use a different size of paper than the original, touch the [PAPER SELECT] key and select the paper tray with the desired paper size. (The selected paper will be highlighted and the paper selecting screen will close.) To close the screen without selecting a paper size, touch the [PAPER SELECT] key again. READY TO COPY. 0 1.8½x11 2.8½x14 PLAIN RECYCLED 11x17 PLAIN EXTRA IMAGE ADJUST AUTO EXPOSURE PAPER SELECT 100% COPY RATIO 4 Select the number of copies and any other desired copy settings, and then press the [START] key ( ). Note If the original size is not automatically detected, manually set the original size. (p.47) 3 Make sure that the same size of paper as the original is automatically selected. ORIGINAL 8½x11 8½x11 8½x14 8½x11 AUTO EXPOSURE AUTO 8½x PAPER SELE 100% COPY RATI The selected tray is highlighted. If the tray contains a different size of paper than the original, "LOAD xxxx PAPER." will appear. Even if the message above is displayed, copying can be performed using the selected paper tray. 22 ACC.#-C • The number in the copy quantity display will decrease by 1 each time a copy is made. • If you are only making a single copy, the copy can be made with the copy number display showing "0". • To clear a mistake, press the [CLEAR] key ( ). Note • Press the [CLEAR] key ( ) to stop copying in the middle of a run. • To repeat the same copy sequence for a different original, simply replace the original and press the [START] key ( ). • If copying stops because the tray has run out of paper, you can resume copying by touching the [PAPER SELECT] key and selecting the bypass tray or a paper tray that has the same size and type of paper loaded in the same orientation.