Sharp AR-M237 AR-M237 AR-M277 Operation Manual Suite - Page 215
Initial Resolution Setting, Initial Exposure Setting, Own Number And Name Set, Dial Mode Setting
View all Sharp AR-M237 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 215 highlights
KEY OPERATOR PROGRAMS INITIAL RESOLUTION SETTING This setting is used to select the default resolution setting for fax mode. Selections are [STANDARD], [FINE], [SUPER FINE], and [ULTRA FINE]. When the resolution is set to [FINE], [SUPER FINE], or [ULTRA FINE], [HALF TONE] can also be selected. To select HALF TONE for the selected resolution setting, touch the [HALF TONE] key so that it is highlighted. The factory default setting is "STANDARD". Note • HALF TONE cannot be selected for STANDARD resolution. • For information on each of the resolution settings, see page 21. INITIAL EXPOSURE SETTING This program is used to set the default exposure for scanning in fax mode. [AUTO] or [MANUAL] can be selected for the exposure. When [MANUAL] is selected, the exposure can be adjusted to one of five levels. [1] is the lightest level and [5] is the darkest level. The factory default setting is "AUTO". OWN NUMBER AND NAME SET Use this program to enter, edit, or delete the fax number of the machine and the sender's name. The entered name and number are printed at the top of each fax page that is sent. The number is also used as a passcode when performing polling reception. You can check your entries by printing out the Sender List in the custom settings. (p.85) Note If multiple senders have been programmed and a sender is not selected, the sender with the lowest control number is automatically selected. Entering the sender's name and number 1 Touch the [ENTER] key. The new entry screen appears. KEY OPERATOR PROGRAMS OWN NUMBER AND NAME SET OK ENTER AMEND/DELETE 3 Touch the [FAX No.] key and enter the fax number. Enter up to 20 digits for the number using the numeric keys. To enter a "+", press the " " key. To enter a hyphen, touch the [PAUSE] key. To enter a space, press the [SPACE] key. If you make a mistake, press the [CLEAR] key ( ) and re-enter the correct digit. 4 Touch the [OK] key. 5 To exit, touch the [EXIT] key. • To enter another sender, touch the [NEXT] key. Editing or deleting a sender 1 Touch the [AMEND/DELETE] key. 2 Touch the sender key that you wish to edit or delete. 3 Touch the keys that wish to edit or delete. • To edit sender information, follow the same steps as when storing the sender. • To delete a sender, touch the [DELETE] key in the upper right corner of the screen and then touch the [YES] key in the message screen that appears. (To cancel the deletion, touch the [NO] key.) DIAL MODE SETTING (Setting your line type) Select the type of telephone line you are on. Touch [TONE] or [PULSE]. The factory default setting is "TONE". PAUSE TIME SETTING This setting is used to select the duration of the pause that is inserted in a destination fax number when the [PAUSE] key is pressed while dialing or storing the number. Any number of seconds from 1 to 15 can be selected. The factory default setting is "2" (sec.). 8 2 Touch the [NAME] key and enter the sender's name. The sender's name entry screen appears. Up to 20 sender's names can be entered. A maximum of 22 characters can be entered for a sender's name. To enter characters, see "ENTERING CHARACTERS" on page 80. You can also program only a name or only a Note number as a sender. 97