Xerox 6180N DocuTech 61xx - Operator HandyBook - Page 101
through the Binder. The tape must be cleared. If the Binder is not inspected for partially fed tape
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Solutions in Alphabetical Order same size as the top cover. If so, there is a handle to raise the transport with. The handle is a black rod with a silver spring on each side and is located on the very front of the transport. 4. Lift the transport and manually hold it in place while paper jams are being cleared. 5. Remove any paper in the right center area of the Finisher, under the Finisher Top Cover, or silver transport area. NOTE: Area 17 is immediately under the Finisher Top Cover, or silver transport area, if so equipped. Area 18 is immediately below area 17. Clearing all paper under the cover or transport area will clear both areas. 6. Open and pull out the Binder using the green square handle immediately to the right of Paper Tray 3. NOTE: When a paper jam occurs in area 18, the machine may have partially fed Binder tape through the Binder. The tape must be cleared. If the Binder is not inspected for partially fed tape and cleared, subsequent jams may occur. 7. A tape reel is located under the Binder and is seen from the right side. Make sure that there is sufficient tape for your job. 8. Locate the knob on the right side of the Binder and rotate the knob to the right to advance the tape approximately 13 mm (0.5 inch). DT6180 HandyBook 101