Xerox 6180N DocuTech 61xx - Operator HandyBook - Page 19
Loading Transparencies, Re-Loading Tabs - printer
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Paper Trays & Loading Media Loading Transparencies The following are the different types and usage of transparencies for Paper Trays 1, 2 and 3. • Transparencies with a 13 mm (0.5 inch) white stripe should be loaded with the white stripe to the right if you are using Paper Trays 1 and 2. Load the shiny side up for optimum performance. • Removable stripe transparencies: Do not load more than 50 removable-stripe transparencies into Paper Trays 1 and 2. With the white stripe to the right, place the transparencies on top of approximately 50 sheets of paper in the tray. Do not run as inserts to a bound job. Printing is not allowed on inserts. • High speed transparencies with paper backing: Run these types of transparencies from Paper Trays 1 and 2 with the paper side down, and from Paper Tray 3 with the paper side up. Re-Loading Tabs For DocuSP version 3.X or higher: There are two methods to replenish tab stock in the paper trays. Option 1: 1. Open the paper tray where the tab stock is loaded. 2. Remove any tabs so that there is a full bank of tabs on top of the stack. 3. Add additional tab stock. 4. Close the paper tray. Option 2: 1. Open the paper tray where the tab stock is loaded. 2. Add additional tab stock to the bottom of stack. 3. From the DocuSP for DocuTech 2000 series 61XX screen, select [Printer Manager]. Information about each paper tray will be displayed. 4. Select the line that has the information about the paper tray you are adding tab stock to. A menu will be displayed. 5. Select [Properties] from the menu. The Tray Properties window will be displayed. 6. Select the check box next to [Set Sequence Position]. The box below the Set Sequence Position box will become active. 7. Enter the number of tabs remaining in the bank of tabs on top of the stack in the paper tray. For example, if there are three tabs remaining on top of the stack in the tray, enter the number [3] in this box. 8. Select the check box next to [Check Override Programming] in the lower, left corner of the window. 9. Select [OK]. 10. Close the paper tray. For DocuSP version 2.X or lower: 1. Open the paper tray where the tab stock is loaded. 2. Remove any tabs so that there is a full bank on top of the stack. 3. Add additional tab stock. 4. Close the paper tray. DT6180 HandyBook 19