Xerox 6180N DocuTech 61xx - Operator HandyBook - Page 26

Paper Trays & Loading Media Stock type • Textured paper • Window stock • Xerox Carbonless Instructions for use Load the paper into trays 1 and 2; side 1 up with the top edge to the front of the tray. Do not use freshly preprinted paper in trays 1 and 2. Heavily textured paper may produce prints with a ragged character appearance or deletions. To test, run a proof print. Run if the window is 2.2 to 4 inches (57 to 102 mm) from the top edge of the paper and at least 1 inch (25.4 mm) from each side of the paper. Run only as the first page or a front cover to avoid finisher bin jams. Load the window stock face-up into a tray (tray 1 or 2 is recommended) with the top edge toward the front of the tray. If running plastic-covered window stock, there may be some distortion. To test, run a proof copy. Xerox Carbonless Paper is recommended. Do not use the following stocks: • Multipart forms • Stocks outside of the recommended size and weight ranges Satisfaction Guide for Stitcher The specifications for stock fed to the Stitcher for reliable stapling are as follows: Size: Weight: Metric 203 mm x 254 mm to 229 mm x 356 mm 60 g/m² to 200 g/m² - Weights outside the above limits are not recommended. Imperial 8 x 10 inches to 9 x 14.33 inches 16 to 110 index / 53 bond or xerographic - Weights outside the above limits are not recommended. NOTE: For larger sizes, send to Top Tray as Unstapled. Set size limit due to copy paper weight: • Collated: Up to 65 sheets of 80 g/m² (20 lb), or 7 mm (0.28 inch) thick sets. Less reliable stapling may be expected from 66 to 70 sheets. • Uncollated: 50 sheets maximum per stitch, 7 mm (0.28 inch) thick sets. Minimum: 2 sheets. Type or condition: Xerographic bond paper in good condition, and drilled or hole-punched paper. The Stacker capacity adjusts automatically to suit various set sizes. DT6180 HandyBook 26