Xerox 6180N DocuTech 61xx - Operator HandyBook - Page 58
Potential Solutions
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 58 highlights
Problem Solving Area Detail Solutions following Problem table? Case # Problem Related Fault Codes Potential Solutions /Solutions Ranked by Relevance: F Loose binder tape along the spine of the completed bound book F Repeated tape feeding problems, such as binder tape not unwinding from the reel F Poor stitch quality or short stitches F 1680 Bins Exit P12-140 Sensor Fault If an adjustment is made to the binder tape length during a job, it will not take effect until the next job is printed. If it is necessary to adjust the binder tape length during a job, adjust it using the procedures in the on-line help. This is a symptom of excessive moisture N in the tape. Replace the tape reel with a new reel using the procedure, "Replace the Binder Tape Reel," in "Replacing Consumables". Refer to the binder tape storage guidelines in the Operator Guide. If the binder tape is sticking together, or if N there are cosmetic defects in the bound book, replace the tape reel with a new reel using the procedure, "Replace the Binder Tape Reel," in "Replacing Consumables". Refer to the binder tape storage information in the Operator Guide. Refer to the binder cleaning information in the Operator Guide. Reliable stitching can be expected with up N to 65 sheets of substance 20 (75 g/m2) or 0.28 inch (7 mm) thick sets. Less reliable stitching can be expected with over 70 sheets of substance 20 (75 g/m2). Running intermixed stock heavier than substance 20 (75 g/m2) will reduce the capacity of the stitcher. To avoid short clinches, use the stitch override only when using a lightweight paper. Stitch override allows the system to run beyond the stitching limit. The system will shut down at 125 sheets. Reduce the stock weight to enable the stitching of more sheets per set. Refer to the satisfaction guides in the "Technical information" chapter. 1. Clear the Paper Jams in Areas 16 Y and 17 2. Clean the Bins Exit Sensors Y (Q1222) DT6180 HandyBook 58