Xerox 6180N DocuTech 61xx - Operator HandyBook - Page 66

Solutions in Alphabetical Order Solutions in Alphabetical Order Clean Finisher Entrance Sensor (Q1201 68 Clean the Bin A Bindexer Sensor (Q1205 71 Clean the Bin B Bindexer Sensor (Q1206 72 Clean the Binder Tape Guide Sensor (Q1213 73 Clean the Bindexer Sensors (Q1205, Q1206, Q1207 74 Clean the Bins Exit Sensors (Q1222 75 Clean the Front Stack (Q1227), Rear Stack Height (Q1218), and Set Path (Q1221) Sensors...77 Clean the Fuser (Q1010) and Prefuser Sensors (Q1009 80 Clean the Post Inverter (Q1202) and Output Transport (Q1203) Sensors 82 Clean the Pre-Fuser Sensor (Q1009 84 Clean the Registration Transport Sensor (Q861 85 Clean the Set Path Sensor (Q1221 86 Clean the Tape Binder Area ...89 Clear Paper Jams in Areas 11, 12, 13, and 14 91 Clear Paper Jams in Areas 11, 12, and 13 94 Clear Paper Jams in Areas 13, 14, and 15 97 Clear Paper Jams in Areas 17 and 18 100 Clear the Entire Paper Path From the Paper Trays to the Finisher 102 Clear the Fault in the Printer Fault Clearance Window 102 Clear the Paper Jam in Area 4 103 Clear the Paper Jam in Areas 11, 14, 17, and 18 103 Clear the Paper Jam in Areas 12, 13, 14, and 15 107 Clear the Paper Jam in Areas 3 and 4 111 Clear the Paper Jam in Areas 5 and 6 112 Clear the Paper Jam in Areas 7, 6, and 5 113 Clear the Paper Jam in Areas 8 and 9 115 Clear the Paper Jam in Areas 8, 11, 12, and 13 116 Clear the Paper Jams in Areas 16 and 17 119 Clear the Paper Jams in Areas 17 and 19 121 Clear the Paper Jams in Areas 7, 6, 5, 4, and 2 123 Clear the Stitcher A Fault ...125 Fan the Paper, Turn the Paper Over, and Reload 127 If Paper is Jammed in the Fuser, Release the Camming Motor Brake 127 If Printing to the Edges of the Paper Stock, set Lead Edge Screening to Stress 128 If the Job is Sent From a DigiPath, Clean the Document Glass on the DigiPath 129 Lower the Decurler Baffle Above Area 7 129 Open and Close the Area 3 and 4 Baffles Securely 130 Open and Close the Area 4 Baffle Securely 130 Open and Close the Area 9 Baffle Securely 131 Open and Close the Finisher Top Cover and the Finisher Front Doors 131 Perform an Immediate Shutdown at the DocuSP 132 Power OFF, Reset the Printer Circuit Breakers, Then Power ON 132 Power OFF, Then Power ON the Printer 133 Push Down on the Stacker Safety Door 134 Read the Meter...135 Release the Camming Motor Brake 135 Remove Paper From Interposer Areas B1 and B2 137 Reset the White Power Switch 138 Select Reset / Restart From the Fault Frame 138 Tap on the Toner (Dry Ink) Cartridge to Loosen the Toner 139 DT6180 HandyBook 66