Xerox 6180N DocuTech 61xx - Operator HandyBook - Page 62
System Fault
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 62 highlights
Problem Solving Area Detail Solutions following Problem table? Case # Problem Related Fault Codes Potential Solutions /Solutions Ranked by Relevance: 2. Load Paper in the Selected Paper Y Tray Correctly (See Paper Trays & Loading Media) 3. Clean the Registration Transport Y Sensor (Q861) 4. Clean the Pre-Fuser Sensor Y (Q1009) 5. Use A New Ream of Paper Y 6. Clear the Fault in the Printer Fault Y Clearance Window 7. Power OFF, Then Power ON the Y Printer P 3853 Fuser P10-201 P10-202 P10-203 1. Power OFF, Then Power ON the Y Temperature P10-204 P10-206 P10-215 P10-210 Printer Faults F 4003 Stacker Height P12-151 P12-222 1. Clear the Paper Jams in Areas 17 Y Sensor Faults and 19 2. Clean the Front Stack (Q1227), Y Rear Stack Height (Q1218), and Set Path (Q1221) Sensors 3. Power OFF, Then Power ON the Y Printer F 4043 Set Path P12-143 P12-144 P12-230 1. Clear the Paper Jams in Areas 17 Y Sensor Fault P12-231 P12-232 P12-233 P12-234 and 19 2. Clean the Set Path Sensor (Q1221) Y 3. Power OFF, Then Power ON the Y Printer F 4077 Stitcher A P12-218 1. Clear the Stitcher A Fault Y Wire Sensor Fault 2. Replace Stitcher A Wire (See Y Replacing Consumables) 3. Power OFF, Then Power ON the Y Printer F 4088 Finisher P12-242 P12-243 P12-244 1. Clear the Paper Jam in Areas 11, Y Interlock P12-245 P12-247 P12-248 14, 17, and 18 Faults 2. Open and Close the Finisher Top Y Cover and the Finisher Front Doors F 4095 Binder Under P12-251 P12-253 P12-254 1. Power OFF, Then Power ON the Y Temperature P12-256 Printer Faults I 4207 Interposer Exit P14-102 P14-105 1. Remove Paper From Interposer Y Sensor Faults Areas B1 and B2 2. Open, Then Close the Left and N Right Interposer Doors 3. Power OFF, Then Power ON the Y Printer P 4322 System Fault P12-518 1. Remove all Prints From the Top N Tray DT6180 HandyBook 62