Xerox 6180N DocuTech 61xx - Operator HandyBook - Page 46
Adjust the Binder Tape Registration
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 46 highlights
Machine Maintenance Adjust the Binder Tape Registration NOTE: Adjusting the top edge of the Binder Tape changes the positioning of the tape. Adjusting the bottom of the Binder Tape changes the length of the tape. To adjust the Binder Tape registration: 1. Make sure that the tape guides are clean and free of glue residue. The tape guides are on the top of the Binder. 2. Measure the adjustment amount for the top edge of a finished book. If the tape is overhanging on the top or bottom, and not covering the bottom or top, then the tape position needs to be adjusted. 3. Open the Finisher Doors. 4. Locate the black Binder tape knob on the front of the Binder Drawer; just to the right of Paper Tray 3. You should see the Binder tape coming out from the bottom and wrapping around the feeder back into the Finisher. The knob is spring loaded and moves in increments to change the location of the Binder tape. Each increment equals a change of 0.1 mm, up or down, on the edge of the book. One full rotation of the knob is equal to 1 mm (0.04 inch). 5. Pull the knob toward you to rotate it for the adjustment. 6. Adjust the tape position by performing one of the following steps: • Pull the knob and rotate it to the right to move the tape toward the top edge of the book, or • Pull the knob and rotate it the left to move the tape toward the bottom edge of the DT6180 HandyBook 46