Yamaha DME32 DME32 Owners Manual - Page 106
Parameter, Range, Description, INPUT, Level, PHASE, SLOPE & TYPE, LOW-MID, HIGH-MID
View all Yamaha DME32 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 106 highlights
100 Chapter 8-Component Guide Part I Section Parameter Range Description INPUT Level MUTE -Infinity dB to 0.0 dB Adjusts the input signal level ON/OFF Mutes the input GAIN -Infinity dB to 0.0 dB Adjusts the LOW output signal level MUTE ON/OFF Mutes the LOW output LOW PHASE FREQ NOR/REV 20.0 Hz-20.0 kHz Inverts the LOW output signal Adjusts the LOW LPF cutoff frequency LPF Gc1 -6 dB to +6 dB Adjusts the LOW LPF gain at the cutoff frequency SLOPE & TYPE 2 Sets the LOW LPF filter slope and type FREQ 20.0 Hz-20.0 kHz Adjusts the LOW-MID HPF cutoff frequency HPF Gc1 -6 dB to +6 dB Adjusts the LOW-MID HPF gain at the cutoff frequency SLOPE & TYPE 2 Sets the LOW-MID HPF filter slope and type GAIN -Infinity dB to 0.0 dB Adjusts the LOW-MID output signal level LOW-MID MUTE ON/OFF Mutes the LOW-MID output PHASE NOR/REV Inverts the LOW-MID output signal FREQ 20.0 Hz-20.0 kHz Adjusts the LOW-MID LPF cutoff frequency LPF Gc1 -6 dB to +6 dB Adjusts the LOW-MID LPF gain at the cutoff frequency SLOPE & TYPE 2 Sets the LOW-MID LPF filter slope and type FREQ 20.0 Hz-20.0 kHz Adjusts the HIGH-MID HPF cutoff frequency HPF Gc1 -6 dB to +6 dB Adjusts the HIGH-MID HPF gain at the cutoff frequency SLOPE & TYPE 2 Sets the HIGH-MID HPF filter slope and type GAIN -Infinity dB to 0.0 dB Adjusts the HIGH-MID output signal level HIGH-MID MUTE ON/OFF Mutes the HIGH-MID output PHASE NOR/REV Inverts the HIGH-MID output signal FREQ 20.0 Hz-20.0 kHz Adjusts the HIGH-MID LPF cutoff frequency LPF Gc1 -6 dB to +6 dB Adjusts the HIGH-MID LPF gain at the cutoff frequency SLOPE & TYPE 2 Sets the HIGH-MID LPF filter slope and type GAIN -Infinity dB to 0.0 dB Adjusts the HIGH output signal level MUTE ON/OFF Mutes the HIGH output HIGH PHASE FREQ NOR/REV 20.0 Hz-20.0 kHz Inverts the HIGH output signal Adjusts the HIGH HPF cutoff frequency HPF Gc1 -6 dB to +6 dB Adjusts the HIGH HPF gain at the cutoff frequency SLOPE & TYPE 2 Sets the HIGH HPF filter slope and type 1. Gc controls appears only when a Gc SLOPE & TYPE filter is selected. For Butterworth, Bessel, and Linkwitz-Riley, the Gc setting is ignored and the Gc value is fixed as follows: Butterworth and Bessel: -3 dB, Linkwitz-Riley: -6 dB. 2. SLOPE & TYPE parameter values are listed in the following table. DME32-Owner's Manual