Yamaha DME32 DME32 Owners Manual - Page 251

Assigning Component Parameters to Control Changes 247 The Control Change window parameters are explained in the following table. Parameter Range Description UNIT 1-4 Component 1 Selects the DME32 containing the parameter to be assigned Selects the component whose parameter is to be assigned Sub No. Parameter 1-256 2 Selects individual components in configurations containing more than one component of the same type Selects the parameter to be assigned Pair All, High, Low Selects 1- or 2-byte Control Changes 1. All available components can be selected. 2. Depends on the selected component. The Sub No. parameter is used to select individual components in configurations that contain more than one component of the same type. For example, in a configuration with "Compressor" and "Compressor(2)" components, Sub No. 1 would select "Compressor" and Sub No. 2 would select "Compressor(2)." The Pair parameter is set according to the variable range of the parameter. For parameters with a variable range of less than 128 steps, Pair should be set to All. Using the All setting for parameters with a variable range greater than 128 steps, however, will lower the resolution, resulting in imprecise control. In this case, the same parameter should be assigned to two Control Changes, one with Pair set to High, the other with Pair set to Low, as shown below. Using two Control Changes to control a single parameter in this way increases the resolution, providing precise control. The Control Change page displays the new assignment, as shown below. To delete an individual assignment, select it, and then click Clear. To delete all assignments, click All Clear. DME32-Owner's Manual