Yamaha DME32 DME32 Owners Manual - Page 120

114 Chapter 8-Component Guide Part I The Delay parameters for all channels are explained in the following table. Section Parameter Range Description LOW, LOW-MID, HIGH-MID, HIGH ms Sample1 ON/OFF DELAY SCALE 0.0-500.0 ms See the following table ON/OFF See the following table Sets the delay time in milliseconds (linked to control below) Sets the delay time in the units chosen using the DELAY SCALE buttons (linked to ms control) Turns the delay on and off Selects the delay units for the Sample controls 1. This control's label depends on the Delay Scale setting. In the DELAY SCALE section, "FS" indicates the selected wordclock frequency, and "340 m/s" and "1,115.5 ft/s" are the speed of sound in meters and feet respectively (air temperature = 14˚C, 57.2˚F). The parameter ranges for the Sample, m, and feet settings are as follows: Samples Meters Feet Delay Scale FS = 48 KHz 0-24000 samples 0.0-170.0 meters 0.0-557.8 feet FS = 44.1 kHz 0-22050 samples Cross The CROSS page features the 4-way crossover controls and crossover graph. Note that the Gc controls (not shown here) appear only when an Adjustable Gc type SLOPE & TYPE filter is selected. The crossover graph at the top of the window displays the crossover settings graphically. A vertical dotted line indicates the crossover frequency of each channel: "L" for low, "ML" for low-mid, "MH" for high-mid, and "H" for high. DME32-Owner's Manual