Yamaha DME32 DME32 Owners Manual - Page 286

MIDI Data Format 285 If (MIDI DATA - Z) < 0 If ((MIDI DATA - Z)/X) > MAX Otherwise → param = 0 → param = MAX → param = INT ((MIDI DATA -Z)/X 4.2 Program Change (Cn) Reception These messages are received if [Program Change RX] is ON and the [Rx CH] matches. However, if [OMNI] is ON, they are received regardless of the channel. These messages are echoed if [Program Change ECHO] is ON. Scene memories are recalled according to the [Program Change Assign Table]. Transmission If [Program Change TX] is ON, this message is transmitted on the [Tx CH] according to the settings of the [Program Change Assign Table] when a scene is recalled. If the scene memory number that was recalled is assigned to more than one Program Change, the lowest-numbered Program Change is transmitted. If [Program Change ECHO] is ON, these messages are echoed. STATUS DATA 1100nnnn Cn 0nnnnnnn nn Program Change Program No. (0-127) 4.3 Parameter Change (byte operation for type 0x00: edit buffer) Reception These messages are received if [Parameter Change RX] is ON and the [Rx CH] matches the Device Channel included in the SUB STATUS of the message. These messages are echoed if [Parameter Change ECHO] is ON. When these messages are received, the corresponding parameter is controlled. Transmission If [Parameter Change TX] is ON, this message is transmitted on the [Tx CH] Device Channel when a parameter not specified in the [Control Change Assign Table] is adjusted. These messages are transmitted without change if [Parameter Change ECHO] is ON. STATUS ID No. SUB STATUS GROUP ID MODEL ID PARAM TYPE DATA EOX 11110000 F0 01000011 43 0001nnnn 1n 00111110 3E 00000101 05 00000000 00 0000aaaa dd1 0000bbbb dd2 0000cccc dd3 0000dddd dd4 0000eeee dd5 0000ffff dd6 0000gggg dd7 0000hhhh dd8 11110111 F7 System Exclusive Message Manufacturer's ID No.(YAMAHA) parameter change or response for request n=0-15 (Device Channel No.1-16) group ID (digital mixer) Device code (DME32) byte operation for edit buffer Parameter No. (H high order bit) Parameter No. (H low order bit) Parameter No. (L high order bit) Parameter No. (L low order bit) Parameter value (H high order bit) Parameter value (H low order bit) Parameter value (L high order bit) Parameter value (L low order bit) End Of Exclusive DME32-Owner's Manual