Yamaha DME32 DME32 Owners Manual - Page 273

DME Manager Error Messages 271 DME Manager Error Messages If DME Manager displays an error message, look for the solution in the following table. Message Reason Solution Cannot compile because configuration contains no components! An attempt was made to compile a configuration that contains no components. Add some components, and then try compiling again. Cannot display more than An attempt was made to display more A maximum of 32 meters can be dis- 32 meters! than 32 meters. played simultaneously. Disable the device using the COM port. COM port open error 5 The COM port is in use by another device. Open the "setup.ini" file in the DME folder and make sure that the COM setting is correct. If you are using com port 2, for example, the setting should be "COM2". Component position error! An error occurred while trying to display the configuration. Try opening the configuration again, or try receiving it from the DME32 again. Configuration must be compiled before saving! An attempt was made to save a config- Compile the configuration, and then try uration that has not been compiled. saving again. Configuration must be compiled before sending! An attempt was made to send an uncompiled configuration to the DME32. Compile the configuration, and then try sending again. DME32 and DME Manager configurations do not match! The DME Manager and DME32 configuration data does not match. Match the data, and then try sending the configuration again. DME32 not found! The DME32 was not detected when DME Manager was started. Continue using only DME Manager, or check the DME32 connection and restart DME Manager. Error reading file! An error occurred while trying to open a file. Perhaps the file is already in use, or has not yet been saved. Check if the file is already in use, or check if it has been saved, and then try opening again. Error receiving configuration! An error occurred while receiving a con- Check the DME32 connection, and then figuration from the DME32. try receiving again. Error sending configuration! An error occurred while sending a con- Check the DME32 connection, and then figuration to the DME32. try sending again. Error writing file! An error occurred while trying to write to a file. Perhaps it's in use, or is write protected. Enter another file name, or turn off the write protection, and then try saving again. Grid spacing is too large The specified grid spacing is too large Enter a grid spacing within the valid or too small! or too small. range. Incorrect password! The password entered was incorrect. Enter the correct password. No configuration selected! An attempt was made to send a configuration, but no configuration was selected. Select a configuration, and then try sending again. "NO DATA" is an invalid file name! "NO DATA" cannot be used as a file name. Enter a file name other than "NO DATA". Not a DME file! An attempt was made to open a file other than a DME file. Open, and drag open only DME files Printer setup error! An error occurred while trying to read the printer setup information. Perhaps the printer is not set up correctly, or a suitable driver is not available. Set up the printer correctly. DME32-Owner's Manual