ZyXEL VMG1312-B10A User Guide - Page 74
Table 8, Label, Description
View all ZyXEL VMG1312-B10A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
Chapter 6 Broadband Table 8 Network Setting > Broadband > Add New WAN Interface/Edit (Routing Mode) (continued) LABEL Service Category DESCRIPTION Select UBR Without PCR or UBR With PCR for applications that are non-time sensitive, such as e-mail. Select CBR (Continuous Bit Rate) to specify fixed (always-on) bandwidth for voice or data traffic. Select Non Realtime VBR (non real-time Variable Bit Rate) for connections that do not require closely controlled delay and delay variation. Select Realtime VBR (real-time Variable Bit Rate) for applications with bursty connections that require closely controlled delay and delay variation. PPP Information (This is available only when you select PPPoE or PPPoA in the Mode field.) PPP User Name Enter the user name exactly as your ISP assigned. If assigned a name in the form user@domain where domain identifies a service name, then enter both components exactly as given. PPP Password Enter the password associated with the user name above. Select password unmask to show your entered password in plain text. PPP Trigger Type Select when to have the Device establish the PPP connection. Auto Connect - select this to not let the connection time out. Connect on Demand - select this to automatically bring up the connection when the Device receives packets destined for the Internet. Authentication Method Manual - select this if you want to manually trigger the connection up. Select an authentication protocol for outgoing connection requests through this WAN interface. PAP - Password Authentication Protocol (PAP) authentication sends user name and password in clear text without using encryption. Select this if your Device accepts PAP only. CHAP - Challenge Handshake Authentication Protocol (CHAP) provides authentication through a shared secret key and uses a three way handshake. Select this if your Device accepts CHAP only. MSCHAP - Microsoft CHAP provides authentication through a shared secret key and uses a three way handshake. It provides improved usability with Microsoft products. Select this if your Device accepts MSCHAP only. Idle Timeout AUTO - Select this if your Device accepts either PAP, CHAP, or MSCHAP authentication method. This value specifies the time in minutes that elapses before the router automatically disconnects from the PPPoE server. PPPoE Service Name PPPoE Passthrough This field is not configurable if you select Auto Connect in the PPP Trigger Type field. Enter the name of your PPPoE service here. This field is available when you select PPPoE encapsulation. In addition to the Device's built-in PPPoE client, you can enable PPPoE pass through to allow up to ten hosts on the LAN to use PPPoE client software on their computers to connect to the ISP via the Device. Each host can have a separate account and a public WAN IP address. PPPoE pass through is an alternative to NAT for application where NAT is not appropriate. Disable PPPoE pass through if you do not need to allow hosts on the LAN to use PPPoE client software on their computers to connect to the ISP. IP Address (This is available only when you select IPv4 Only or IPv6/IPv4 DualStack in the IPv6/IPv4 Mode field.) VMG1312-B Series User's Guide 74