ZyXEL VMG1312-B10A User Guide - Page 78
Table 9, Label, Description
View all ZyXEL VMG1312-B10A manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 78 highlights
Chapter 6 Broadband Figure 23 Network Setting > Broadband > Add New WAN Interface/Edit (Bridge Mode) The following table describes the fields in this screen. Table 9 Network Setting > Broadband > Add New WAN Interface/Edit (Bridge Mode) LABEL General Active Name Type Mode VLAN Active 802.1p DESCRIPTION Select this to enable the interface. Enter a service name of the connection. Select ADSL/VDSL over PTM as the interface that you want to configure. The Device uses the VDSL technology for data transmission over the DSL port. Select Bridge when your ISP provides you more than one IP address and you want the connected computers to get individual IP address from ISP's DHCP server directly. If you select Bridge, you cannot use routing functions, such as QoS, Firewall, DHCP server and NAT on traffic from the selected LAN port(s). This section is available only when you select ADSL/VDSL over PTM in the Type field. Select this to enable VLAN on this WAN interface. IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that contains bits to define class of service. 802.1q QoS Rate Limit Apply Cancel Select the IEEE 802.1p priority level (from 0 to 7) to add to traffic through this connection. The greater the number, the higher the priority level. Type the VLAN ID number (from 0 to 4094) for traffic through this connection. Enter the rate limit for the connection. This is the maximum transmission rate allowed for traffic on this connection. Click Apply to save your changes. Click Cancel to exit this screen without saving. VMG1312-B Series User's Guide 78