3Com 8760 User Guide - Page 146

CHAPTER 5: COMMAND LINE INTERFACE SNMP Commands Controls access to this access point from management stations using the Simple Network Management Protocol (SNMP), as well as the hosts that will receive trap messages. Table 17 SNMP Commands Command snmp-server community snmp-server contact snmp-server location snmp-server enable server snmp-server host snmp-server trap snmp-server engine id snmp-server user snmp-server targets snmp-server filter snmp-server filter-assignments show snmp groups show snmp users show snmp group-assignments show snmp target show snmp filter show snmp filter-assignments show snmp Function Mode Sets up the community access string to permit access GC to SNMP commands Sets the system contact string GC Sets the system location string GC Enables SNMP service and traps GC Specifies the recipient of an SNMP notification GC operation Enables specific SNMP notifications GC Sets the engine ID for SNMP v3 GC Sets the name of the SNMP v3 user GC Configures SNMP v3 notification targets GC Configures SNMP v3 notification filters GC Assigns SNMP v3 notification filters to targets GC Displays the pre-defined SNMP v3 groups Exec Displays SNMP v3 user settings Exec Displays the assignment of users to SNMP v3 groups Exec Displays the SNMP v3 notification targets Exec Displays the SNMP v3 notification filters Exec Displays the SNMP v3 notification filter assignments Exec Displays the status of SNMP communications Exec Page 5-45 5-45 5-46 5-47 5-47 5-48 5-50 5-51 5-52 5-53 5-54 5-55 5-56 5-56 5-57 5-57 5-58 5-59 5-44