3Com 8760 User Guide - Page 156

CHAPTER 5: COMMAND LINE INTERFACE Default Setting None Command Mode Global Configuration Command Usage • The access point allows up to 10 notification filters to be created. Each filter can be defined by up to 20 MIB subtree ID entries. • Use the command more than once with the same filter ID to build a filter that includes or excludes multiple MIB objects. Note that the filter entries are applied in the sequence that they are defined. • The MIB subtree must be defined in the form ".1.3.6.1" and always start with a ".". • The mask is a hexadecimal value with each bit masking the corresponding ID in the MIB subtree. A "1" in the mask indicates an exact match and a "0" indicates a "wild card." For example, a mask value of 0xFFBF provides a bit mask "1111 1111 1011 1111." If applied to the subtree 1.3.6.1.2.1.2.2.1.1.23, the zero corresponds to the 10th subtree ID. When there are more subtree IDs than bits in the mask, the mask is padded with ones. Example Enterprise AP(config)#snmp-server filter trapfilter include .1 Enterprise AP(config)#snmp-server filter trapfilter exclude .1.3.6.1.2.1.2.2.1.1.23 snmp-server filter-assignments This command assigns SNMP v3 notification filters to targets. Use the no form to remove an SNMP v3 filter assignment. Syntax snmp-server filter-assignments no snmp-server filter-assignments • target-id - A user-defined name that identifies a receiver of SNMP notifications. (Maximum length: 32 characters) • filter-id - A user-defined name that identifies an SNMP v3 notification filter. (Maximum length: 32 characters) 5-54