3Com 8760 User Guide - Page 193

Using the Command Line Interface Enterprise AP#show bridge link wireless a 2 Port-No : 11 status : Enabled state : Disabled priority : 0 path cost : 19 message age Timer : Inactive message age : 4469 designated-root : priority = 32768, MAC = 00:30:F1:F0:9A:9C designated-cost : 0 designated-bridge : priority = 32768, MAC = 00:30:F1:F0:9A:9C designated-port : priority = 0, port No = 11 forward-transitions : 0 Enterprise AP# Enterprise AP#show bridge link ethernet status : Enabled state : Forwarding priority : 0 path cost : 19 message age Timer : Inactive message age : 4346 designated-root : priority = 32768, MAC = 00:30:F1:F0:9A:9C designated-cost : 0 designated-bridge : priority = 32768, MAC = 00:30:F1:F0:9A:9C designated-port : priority = 0, port No = 1 forward-transitions : 1 Enterprise AP# Spanning Tree Commands The commands described in this section are used to set the MAC address table aging time and spanning tree parameters for both the Ethernet and wireless interfaces. Table 24 Bridge Commands Command bridge stp enable bridge stp forwarding-delay bridge stp hello-time bridge stp max-age bridge stp priority bridge-link path-cost bridge-link port-priority Function Enables the Spanning Tree feature Configures the spanning tree bridge forward time Configures the spanning tree bridge hello time Configures the spanning tree bridge maximum age Configures the spanning tree bridge priority Configures the spanning tree path cost of a port Configures the spanning tree priority of a port Mode GC GC GC GC GC IC IC Page 5-92 5-92 5-93 5-94 5-94 5-95 5-96 5-91