3Com 8760 User Guide - Page 247
VLAN Commands, connectivity to the access point and wireless clients, be sure that the access point - 802 1q
UPC - 662705506531
View all 3Com 8760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 247 highlights
Using the Command Line Interface between access points from different vendors. This command is used to enable or disable 802.11f handover signaling between different access points, especially in a multi-vendor environment. Example Enterprise AP(config)#iapp Enterprise AP(config)# VLAN Commands The access point can enable the support of VLAN-tagged traffic passing between wireless clients and the wired network. Up to 64 VLAN IDs can be mapped to specific wireless clients, allowing users to remain within the same VLAN as they move around a campus site. When VLAN is enabled on the access point, a VLAN ID (a number between 1 and 4094) can be assigned to each client after successful authentication using IEEE 802.1X and a central RADIUS server. The user VLAN IDs must be configured on the RADIUS server for each user authorized to access the network. If a user does not have a configured VLAN ID, the access point assigns the user to its own configured native VLAN ID. NOTE: When VLANs are enabled, the access point's Ethernet port drops all received traffic that does not include a VLAN tag. To maintain network connectivity to the access point and wireless clients, be sure that the access point is connected to a device port on a wired network that supports IEEE 802.1Q VLAN tags. The VLAN commands supported by the access point are listed below. Table 30 VLAN Commands Command vlan managementvlanid vlan-id Function Mode Enables a single VLAN for all traffic GC Configures the management VLAN for the access point GC Page 5-146 5-146 Configures the default VLAN for the VAP interface IC-W-VAP 5-147 5-145