3Com 8760 User Guide - Page 197

Using the Command Line Interface Default Setting 32768 Command Mode Global Configuration Command Usage Bridge priority is used in selecting the root device, root port, and designated port. The device with the highest priority becomes the STP root device. However, if all devices have the same priority, the device with the lowest MAC address will then become the root device. Example Enterprise AP(config)#bridge stp-bridge priority 40000 Enterprise AP(config)# bridge-link path-cost Use this command to configure the spanning tree path cost for the specified port. Syntax bridge-link path-cost • index - Specifies the bridge link number on the wireless bridge. (Range: 1-6 required on wireless interface only) • cost - The path cost for the port. (Range: 1-65535) Default Setting 19 Command Mode Interface Configuration Command Usage • This command is used by the Spanning Tree Protocol to determine the best path between devices. Therefore, lower values should be assigned to ports attached to faster media, and higher values assigned to ports with slower media. • Path cost takes precedence over port priority. Example Enterprise AP(if-wireless a)#bridge-link path-cost 1 50 Enterprise AP(if-wireless a)# 5-95