3Com 8760 User Guide - Page 155
snmp-server filter, Command Mode
UPC - 662705506531
View all 3Com 8760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 155 highlights
Using the Command Line Interface • ip-addr - Specifies the IP address of the management station to receive notifications. • sec-name - The defined SNMP v3 user name that is to receive notifications. • version - The SNMP version of notifications. Currently only version 3 is supported in this command. • udp-port - The UDP port that is used on the receiving management station for notifications. • notification-type - The type of notification that is sent. Currently only TRAP is supported. Default Setting None Command Mode Global Configuration Command Usage • The access point supports up to 10 SNMP v3 target IDs. • The SNMP v3 user name that is specified in the target must first be configured using the snmp-server user command. Example Enterprise AP(config)#snmp-server targets mytraps 192.254.2.33 chris Enterprise AP(config)# snmp-server filter This command configures SNMP v3 notification filters. Use the no form to delete an SNMP v3 filter or remove a subtree from a filter. Syntax snmp-server filter [mask {mask}] no snmp-server filter [subtree] • filter-id - A user-defined name that identifies an SNMP v3 notification filter. (Maximum length: 32 characters) • include - Defines a filter type that includes objects in the MIB subtree. • exclude - Defines a filter type that excludes objects in the MIB subtree. • subtree - The part of the MIB subtree that is to be filtered. • mask - An optional hexadecimal value bit mask to define objects in the MIB subtree. 5-53