3Com 8760 User Guide - Page 74
Configuring SNTP, Enter Time Zone
UPC - 662705506531
View all 3Com 8760 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 74 highlights
CHAPTER 4: SYSTEM CONFIGURATION Enter Time Zone - Sets the desired time zone + or - GMT. Enable Daylight Saving - Adjusts the clock for summertime and wintertime. The system allows you to limit the messages that are logged by specifying a minimum severity level. The following table lists the error message levels from the most severe (Emergency) to least severe (Debug). The message levels that are logged include the specified minimum level up to the Emergency level. Table 3 Logging Levels Error Level Description Emergency System unusable Alerts Immediate action needed Critical Critical conditions (e.g., memory allocation, or free memory error - resource exhausted) Error Error conditions (e.g., invalid input, default used) Warning Warning conditions (e.g., return false, unexpected return) Notice Normal but significant condition, such as cold start Informational Informational messages only Debug Debugging messages NOTE: The access point error log can be viewed using the Event Logs window in the Status section (page 4-61). The Event Logs window displays the last 128 messages logged in chronological order, from the newest to the oldest. Log messages saved in the access point's memory are erased when the device is rebooted. CONFIGURING SNTP Simple Network Time Protocol (SNTP) allows the access point to set its internal clock based on periodic updates from a time server (SNTP or NTP). Maintaining an accurate time on the access point enables the system log to record meaningful dates and times for event entries. If the clock is not set, the access point will only record the time from the factory default set at the last bootup. The access point acts as an SNTP client, periodically sending time synchronization requests to specific time servers. You can configure up to two time server IP addresses. The access point will attempt to poll each server in the configured sequence. SNTP Server - Configures the access point to operate as an SNTP client. When enabled, at least one time server IP address must be specified. Primary Server: The IP address of an SNTP or NTP time server that the access point attempts to poll for a time update. 4-34